So it has been a long time since I have been doing much with my projects as life in its usual way as gone off on a tangent. Lately though I have finally had a chance to get into my scratch building projects again.

Now I have been getting back into this project to make 15 KFA log carriers converted from cargowaggens. I have had the ends 3D printed and have hand built most if the stays and am now at the point of assembling the everything together.

In the shots below we can see that the pints came out pretty good although they needed a lot of cleaning which was easy enough by time consuming getting all the soft resin off. Then the just get a primer paint finish.