Axle Box Springs
As I mentioned in my introduction regarding 3D printing, I decided to produce my own axle boxes as there were none available that resembled the Cambrian one. I was fortunately able to obtain some good photos of the loco and a works drawing which helped me design the axle box. After creating a 3D model it was then saved out as a stl file for 3D printing. I am awaiting delivery from Shapeways where I have sent my stl file for printing using their frosted extreme detail material. The axle boxes will be printed at 16 microns which is .01mm layer thickness. If the prints are satisfactory Dragon Models has asked if they can have a set to cast from. Depending on the quality of the castings I may either use the castings or 3D prints on the loco.
- 4
6 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now