Hattons delivers to Denmark in less than 36 hours!
The first pack of the new DCC track arrived today. Here are a few very bad pictures that compare it with Tillig elite and Hornby set track.
In case anyone is in doubt the DCC is at the top, the Tillig in the middle and the Hornby at the bottom.
First impressions: well I love the sleepers distance which likes right to me ( I know it’s wrong Martin ) but I last travelled by train in the UK about 27 years ago so that’s my excuse. I have to say the Tillig track if you ignore the fact that it is HO is probably just as good if not better especially because of the pre weathered rails. As for the Hornby…
When I first looked at it end on I thought that the inwards leaning of the rail was hardly noticeable, but when put alongside other track it becomes very obvious. What I have not shown is that I also bought just the rail and a Maplin solder station, so as you can hear I have been persuaded to have a go at point work.
I also have lots of extruded foam, plywood and as a brand new birthday present, a bench saw to cut it all up with. So frustration from points building will be taken out on bashing screws into baseboards. My tool bench consists of a nail gun and hammer. I have an axe as well but find it hard to be precise in the fine trimming with that.
- 5
4 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now