You may remember Me building a On30 Backwoods Miniatures Aerocar but bust the motor when fitting the prop
well i have replaced it with one from a small radio controlled helicopter keeping the radio control so that tha Aerocar now runs am battery power
heres some video
test1
test 2
drivers will have fun with this as it will only go one way ;D
todays running was a lot easier with 2 than 1 operater
Ther was some intensive movments today here are some videos that i took
2-6-0 on the passinger train
railcars
Boxcab pulling hoppers
The shay pulling its logging cars
All ran well today & i am happy with the layout
heres a quick video of the layout from today sorry for the qualtiy as its from my phone & i will take my camarer with me tomorrow
well the relayed track has been painted & all is now packed ready to put in the car tomorrow morning
also picked up a Bachmann gondola to boost stock
So if anyone is around Uppermill over the weekend call & say Hi
Well i have got the track down today & i am about to do some of the wiring
At the mo the yards can only work with Forks as i have run of of track but i will fit the bridging tracks to the outer ends before the CRM show so the yards can be put anywere withing the On30 Modules
note to self must pick up some small door nobs them screws are sharp
HELP
Forks Trestle is now filling in on november 28th/29th 2009 @ the show in Uppermill
I have a passinger train & a logging train plus a small goods train at the mo but look to the CRM for stock transfers to increas trains
O & a Model T railcar
Plus i Need to build the fiddleyards
since the old rmweb is not always on line at the mo here is a link to some pics of Forks Trestle over on Fotopic
http://mozzer-models...t/c1723581.html
i now have the wood to build the boards so this can be used as a stand alone layout
As part of the CRM 0n30 Modular Layout i am building a valley Modular which will have a wooden trestle bridge going across it
The standard for the modules is to have the track at four inches above table level, Forks Trestle will hang between two tables though and the rest of the modules will then be placed either side of it. This arrangement works OK, we have a single OO scale module which drops below table level too, but it is strictly one drop down section per assembly because varying table