It's been a while since I last worked on this coach, but now I have a new soldering iron progress can continue.

When I left off there were the following jobs remaining
-interior
-roof detail
-hinges
-corridor connections
-drop lights

The hinges and drop lights should have been fine before fixing the sides to the ends. Doing them after certainly added complexity. I tried to use masking tape to hold in place while I tacked in place, but a combination of tight access and my lumpy soldering on the ends made it tricky for the door windows

The corridor was a lot easier, but glazing the model will be fun, as there's next to no material between the edge of the drop light etch and the edge of the window. If only they had just been half etched as part of the side!

With the drop lights in, the next job was to glue on some cast corridors and pipes

Shown is the more interesting side of the coach, which gives
The design it's name