Jump to content
 

Class 92 And the Scottish sleeper photos


Recommended Posts

  • RMweb Premium

I have recently been lucky enough to see and photo a rare loco as far down south as I am. A Caledonian sleeper liveried 92 and it was in dollands moor. It prompted me to see if I could upload the pics to a topic on Rmweb for everyone to see. On searching there was no topic to this great loco, so I've started one. Please feel free to post pictures and discussions on this topic.

 

So here to start are the 92 pictures from dollands moor

post-17016-0-77707400-1462511014_thumb.jpg

post-17016-0-33997600-1462511034_thumb.jpg

post-17016-0-16293800-1462511045_thumb.jpg

post-17016-0-32693000-1462511056_thumb.jpg

post-17016-0-87511100-1462511225_thumb.jpeg

post-17016-0-22751300-1462511234_thumb.jpeg

post-17016-0-12965600-1462511244_thumb.jpeg

post-17016-0-54720000-1462511251_thumb.jpeg

post-17016-0-75974600-1462511259_thumb.jpeg

Edited by GWRPhil
  • Like 18
Link to post
Share on other sites

Aren't the CS loco's actually leased to them from GBRF, if so it's probably standing in for a GBRF one?

Oddly enough the only time i've shot a CS 92 it wasn't pulling a sleeper train either! 

(92018 plus DIT 90041, Rugeley TV, 25/9/15)

92018_90041_RugeleyTV_25092015%20%28171%

Back to normality - 92041 passing through Kensington Olympia with the empty Ebange steel empties, 12th Oct 2009

92041_KensingtonOlympia_121009%20%2824%2

  • Like 12
Link to post
Share on other sites

  • 2 weeks later...
  • RMweb Premium

I must try and dig out my 92 photos.  They are very good looking locos.   I once saw one on the test train with the ill fated Euronight stock heading north at Warrington but seem to remember that I only managed to snap the train going away.  Thanks for starting this thread.

 

Jamie

  • Like 1
Link to post
Share on other sites

If you've got any photos please feel free to post them.

 

 

Here is 92044 passing Norton Bridge with a container train in 1999

 

 

post-4474-0-13867700-1463302824_thumb.jpg

 

 

 

And 92007 caught on camera as best as possible through the maze of wires and supports at Willesden Low Level in 2006

 

 

post-4474-0-35083400-1463302832.jpg

  • Like 9
Link to post
Share on other sites

I wonder if it is providing cover for a 92 that would normally be at Dollands Moor?

It's been at Coquelles for maintenance; all the GBRf 92s are diagrammed to pass through there. They used to work down on the intermodal from Daventry to Italy (Norfolk Line), but this hasn't run for a while, so they run down light engine.

Link to post
Share on other sites

A couple from me. My least favourite class of loco, but worthy of photography nonetheless.

 

 

25/7/14 92 016 at Eden Valley loop.

post-7504-0-69896400-1463345866_thumb.jpg

 

 

30/06/2006. 92 022 in the Up bay at Warrington Bank Quay.

post-7504-0-81098800-1463345876_thumb.jpg

 

 

30/06/2006. 92 022 heading north with log carrying wagons. Don't know the reporting number or destination of this service. 

post-7504-0-66038000-1463345887_thumb.jpg

 

Somewhere near Lichfield Trent Valley ( I forget where exactly), waiting at a red due to a track circuit failure ahead. Although not a complete view, it does give some idea of the cab layout of these god awful things. 

post-7504-0-51003600-1463345949_thumb.jpg

  • Like 9
Link to post
Share on other sites

A couple from me. My least favourite class of loco, but worthy of photography nonetheless.

 

 

25/7/14 92 016 at Eden Valley loop.

attachicon.gif92016small1.jpg

 

 

30/06/2006. 92 022 in the Up bay at Warrington Bank Quay.

attachicon.gif92022wbq.jpg

 

 

30/06/2006. 92 022 heading north with log carrying wagons. Don't know the reporting number or destination of this service. 

attachicon.gif92022wbq2.jpg

 

Somewhere near Lichfield Trent Valley ( I forget where exactly), waiting at a red due to a track circuit failure ahead. Although not a complete view, it does give some idea of the cab layout of these god awful things. 

attachicon.gif92cab1.jpg

Why pray tell do you refer to them as "God awful things"?

Link to post
Share on other sites

Why pray tell do you refer to them as "God awful things"?

Because I've had  the unfortunate pleasure of driving them. Whether it's the driving seat with the unadjustable back rest, the windows that are a finger trap hazard, the fact that all the controls work in the opposite direction to everything else on the network or the fact that they throw their teddies out with frightening regularity, I just don't like them. That's why!

Link to post
Share on other sites

Why pray tell do you refer to them as "God awful things"?

I've called them worse names, especially when they've decided they want to stop in the tunnel; I had the same one (92001, I can remember the number 15 years on) stop on three consecutive mornings on the same train. They seem to have had a disproportionate number of problems over the years, possibly being overly-sensitive to fluctuations in line voltage.

Link to post
Share on other sites

I've called them worse names, especially when they've decided they want to stop in the tunnel; I had the same one (92001, I can remember the number 15 years on) stop on three consecutive mornings on the same train. They seem to have had a disproportionate number of problems over the years, possibly being overly-sensitive to fluctuations in line voltage.

will probably be writing an article about them at some point, so all information regarding their performance from a drivers perspective is helpful. I have read about their propensity for sitting down if they don't like the amount of leccy in the lines!

Link to post
Share on other sites

  • RMweb Premium

will probably be writing an article about them at some point, so all information regarding their performance from a drivers perspective is helpful. I have read about their propensity for sitting down if they don't like the amount of leccy in the lines!

Apparently that propensity has been messing up the Scottish sleepers a lot. There's one patch of line on the WCML that's particularly prone to voltage fluctuations, and the 92s sit down and refuse to go further. Not a problem for 86s, 87s, and 90s, they just ignore it and power on. I'll be interested to see how the new 88s cope. At least if they sit down they can fire up the diesel and limp clear.

Link to post
Share on other sites

will probably be writing an article about them at some point, so all information regarding their performance from a drivers perspective is helpful. I have read about their propensity for sitting down if they don't like the amount of leccy in the lines!

 

Could be down to the interference current monitoring software. Go over the limit and the loco sits down in order to save the signalling.  There seemed to be quite a lot of paranoia about how such a complex and powerful loco might affect signalling circuits, and unfortunately the limits set were far below the amount of interference that other locos put out which everything seemed perfectly happy with.

 

A probably little known fact - Due to the immense power of these locos the buffers and drawgear are insulated to ensure that all the return current when operating on third rail actually goes through the brushes on the axles rather than finding its way through the drawgear and bearings of the wagons behind...

  • Like 1
Link to post
Share on other sites

  • RMweb Gold

While I was sorting out some photos today I came across this one.

 

It was taken at Ulgham Lane crossing, which is on the ECML north of Morpeth, between Newcastle and Edinburgh in July 2007.

 

 

post-5613-0-75124500-1463434528_thumb.jpg

Ulgham Lane Crossing 92029 down freight 4th July 2007 DSC_1829

 

 

David

Edited by DaveF
  • Like 10
Link to post
Share on other sites

  • 3 weeks later...
  • RMweb Premium

Could be down to the interference current monitoring software. Go over the limit and the loco sits down in order to save the signalling.  There seemed to be quite a lot of paranoia about how such a complex and powerful loco might affect signalling circuits, and unfortunately the limits set were far below the amount of interference that other locos put out which everything seemed perfectly happy with.

 

A probably little known fact - Due to the immense power of these locos the buffers and drawgear are insulated to ensure that all the return current when operating on third rail actually goes through the brushes on the axles rather than finding its way through the drawgear and bearings of the wagons behind...

 

It needs to be remembered that the 92s were the first use of AC traction motors in a British locomotive (as opposed to an EMU - the Networkers being the first unit to feature them) and as such display many of the problems common to the 1st of anything new. This is compounded by the complexity of their operations - having to squeeze in TVM430 in cab signalling, having key electrical gear duplicated and enhanced fire suppression systems for tunnel use, a very high current draw on 750V DC to cope with the heavy freights and 'Nightstar' sleepers for 3rd rail land plus all the BR 25KV stuff.

 

Its also worth remembering just how technology has changed in 20 odd years. At the time the 92s were being designed the cutting edge of technology in computing terms was Windows 3.0 with the control gear needed to actually make use of AC drive technology being rather bulky and relatively crude. As such line voltage fluctuations could well cause such early electronics problems.

 

20 years on the rate of progress is such that the class 88s will be far more refined in terms of their electronics and are unlikely to suffer the same fate - though of course they have the advantage of not having all the extra stuff / restrictions that the Channel Tunnel poses.

Edited by phil-b259
  • Like 1
Link to post
Share on other sites

For sake of balance, here's one from "the other side" - 92026 at Fréthun, March 1998.

 

attachicon.gifA9814.jpg

"There is a corner of a loco cab in a foreign yard that will remain forever England" .......................................

 

 

 

(with apologies to Rupert Brooke)

Edited by Southernman46
  • Like 2
Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...