andi4x4 Posted July 31, 2017 Share Posted July 31, 2017 Hi Folks, I recently acquired from ebay a Steve Beattie resin bodied Class 25 kit in untouched, unstarted, complete condition. However - I have no instructions, and the body sides have warped inwards (presumably during the casting/curing stage) So, Can anyone advise how best to straighten the sides ? Boiling water and clamping/pressing maybe ? and Can anyone point me in the right direction for a set of build instructions for the Class 25 resin kit ? Thanks in advance ! Andi Link to post Share on other sites More sharing options...
muddys-blues Posted July 31, 2017 Share Posted July 31, 2017 (edited) Hello Andi, resin kits can be sort of straightened out by gently placing the offending area over a boiling kettle at a few seconds at a time, and then moving back into shape with your hands, be careful scalding yourself on the steam, and the secret is not to leave the area too long over the steam or you can make it worse, I would suggest using some of the industrial gloves to protect your fingers form the heat and steam. PS with regards to the instructions put a wanted add on the wanted section of the forum, there are plenty of helpful souls on here. Hope this helps Craig. Edited July 31, 2017 by muddys-blues Link to post Share on other sites More sharing options...
peter220950 Posted July 31, 2017 Share Posted July 31, 2017 (edited) Andi, It's also worth sending a PM to Steve himself, if you look up the RMWeb members list you will find him, he might have a set, or be able to source one. Peter Edited July 31, 2017 by peter220950 Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now