athegn Posted May 15, 2018 Share Posted May 15, 2018 I am returning to use my Lenz units on a new layout. Due to dodgy wiring I may have caused my LZV100 to need a reset. First questions. How can I tell which software version it has? My LH100 has version 3.0 written on that. At present my LZV100, with only a TR100 connected, gives a reading of 17VAC across ports UV but 0VAC across ports JK (except for a brief flash of 19VAC for a fraction of a second before showing 0VAC). The LED shows constant red. If I need to do a reset what is the exact sequence of key presses I should use? I have tried C1 > 00 > Enter > F > 4 a number of times on my LH100. But all I get after F is the display showing PROG. Press 4 x 20 times seems to do nothing. Any advice please? Link to post Share on other sites More sharing options...
34theletterbetweenB&D Posted May 16, 2018 Share Posted May 16, 2018 Clear display, put in four zeroes, then 'Enter', then press button 4 up to 25 times, if my recollection is correct. Link to post Share on other sites More sharing options...
John K Posted May 16, 2018 Share Posted May 16, 2018 Or failing all else read the manual. Link to post Share on other sites More sharing options...
athegn Posted May 17, 2018 Author Share Posted May 17, 2018 Clear display, put in four zeroes, then 'Enter', then press button 4 up to 25 times, if my recollection is correct. Thank you. Only pressed 20 times. Now all working. Also found a RRamp meter that showed correct DCC voltage. 1 Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now