philsandy Posted December 12, 2018 Share Posted December 12, 2018 (edited) I have built ratio signals before but not a junction signal. The instructions are up to the usual Ratio standard, vague to put it mildly. The 4 cranks are super glued to the two 16mm long wires, so each wire/crank assembly can rotate as one. My question is are the 4 operating wires (1 & 4 from the semaphore arms, and 2 & 3 to the levers) also super glued in the cranks, or as I suspect left free, so the crank can pivot around the wire? Edited December 13, 2018 by philsandy Link to post Share on other sites More sharing options...
RMweb Premium Ray H Posted December 13, 2018 RMweb Premium Share Posted December 13, 2018 I haven't built a Ratio junction signal but looking at your picture I would have thought that all four wires - 1 to 4 - should be left unglued as they will need to effectively rotate in the hole into which they need to be pushed. Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now