Jump to content
 
  • entries
    8
  • comments
    26
  • views
    1,625

About this blog

How to build an inglenook layout in N gauge. Or rather how not to build one.

Entries in this blog

Inglenook

I’m Rubbish at Laying Track

The baseboard I bought was only 5mm ply. This means that I needed to glue and pin some 2”x1” to the underside where my track was going so that it could pin properly and not just pop-out.   Unfortunately, I’d already laid the track, fitted the Twist Lock point motors and trimmed their pins to length (more on that later) before I realised this. So I had to leave “gaps” where the point motors were, which means the actual points themselves couldn’t be pinned down or else the pins ended up
PeterStiles

PeterStiles in Inglenook

3
×
×
  • Create New...