DCC Meltdown
Have rewired the first and second boards now and I am sure you will agree that they are a lot prettier. Have been thinking about the control panels and think that rather than having switches for each point, I shall have route switches that will select all points on that part of the loop which should drastically reduce the chances of running into a close point.
Obvious question here is why don't I just use DCC? Answer is two part: 1) I just prefer the idea of a route panel and 2) My DCC has stopped working!
Yes, a bit of a disaster and a warning for the future. It is a NCE Power cab and when I plug the handset in it goes into the start up screen then switches off and then goes into start up again. I t is almost as if there is a constant short but it does it even if not connected to layout (which works fine in DC). Any ideas anyone?
I shall be on the various DCC forums later and if this fails back to DCC Supplies - it is less than 2 years old and has only been used a handful of times as up to this point I have not had a layout!
Oh, and finished undercoating the figures.
2 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now