To illustrate what I said in the previous post, here is a photo of the front part of the red and orange 'swoops' modified to show nearer where they should be going. I have subsequently trimmed the lower orange bit and reseated it at a slightly better angle. The point of the red should end under the headlight and intersect the tail light while the orange should pass under the taillight with only a very slight overlap of the rim.

Fixing this will entail a little hand painting although that's not too bad to do. The ERG vinyls take a lot of the drudgery out of doing this livery. For completeness, I will also have to add some red stripes around the inner ends to continue the lower body stripes.

Edit: I took a quick (rushed! Sorry about the blurriness) photo of the corrected angle and position for those front stripes. There is too much red and orange showing still but it gives a better idea of what should be.

As can be seen, in daylight the 'Barbie' blue is slightly different but it's as close as I will get to being correct for now. I think it is better than leaving the roof in the dark grey it left the factory with, and likewise at the inner end it is better than leaving the light grey.