Previously I had installed a three way signal on the layout and thought I'd show you how this comes up on the ECoS screen as it's a bit more interesting than the regular two position ones. This is the one to the top right of the screen. When you press it first it opens up to show three signal positions which you can choose from. Installing one of these signals uses two outputs from your point decoder. Once wired up it works quite well though.

Here's the signal on the layout on the right of the below picture.

Station signs were needed to start outfitting the station platforms. The signs were created using the Tannenberg font. I did a bit of a search on this and this is what the dreischeibe forum seemed to consider was correct for the period. Looks about right but not entirely convinced so if you know better, let me know what is a more appropriate font. This is the making of the signs and instalation.

I tidied up the platform underpass entrances with sides and banisters. I made steps as well.

The station building got some flower boxes and period railway posters. Still thinking about how to do the station surrounds. Will do a bit more research on this.

The local historical society did a re-enactment of the visit by the Bavarian King Ludwig II with his entourage in his royal railway carriage pulled by the legendary S2/6.

There was also a nostalgia special to Vienna for enthusiasts pulled by the S3/6.

I was looking into point rodding and ducting and had a bit of a learning curve on the mechanisms used in the period for switching points and signals. I bought some of the Auhagen parts to see what they were like. I'll also order some of the Weinert ones to try out too to see cost versus detail and take it from there. I've installed some of it so far so here is how it looks with the rope pull holders and switching lanterns etc.

Still looking at rolling stock and need to start building up more of a Bavarian Era 2 fleet. Most of the Era 2 stock I have is Berlin based rather than Bavarian. I'll need to start building up a fleet of Era 2 Bavarian stock so have my eye on a few to get once funds become available. I've ordered a couple of electrics which are appropriate and will start buying catenary to install. Might have to just install the masts initially and fill in the power cables later so I can keep access open.

I will also have to figure how I'm going to manage the join between the new Fife layout and this one. I've made the baseboards for the new one and will need to allow clearance for trains to run underneath the new one. This might make the new layout a bit high.

Well home beckons and I'm off back to Scotland for the next couple of months with side trips to Yorkshire and Berlin so nothing will be happening on the layout while I'm away. I'll be coming back with loads of goodies to get cracking with on the new layout when I get back though so plenty to look forward to. Just a couple more pictures to finish with.