I haven't done an update recently, but I have been busy. I decided to make a new coal hole from scratch, which was a lot more fun than building the engine shed. I have also started ballasting the track to the rear / back of the layout and carry out some scenic work at the bottom of the retaining walls.

Having an issue with the water in the top, decided to use clear Yacht varnish and PVA layers. I started with a thin layer of PVA then a layer of Yacht varnish which I think may have been a bit thick (bit like me!). When I thought this was dry I put another layer of PVA on, turns out the varnish may have set on the surface but wasn't fully dry all the way down. I'm thinking thinner layers of varnish in the future. Also my modelling is restricted to the conservatory which isn't the warmest place this time of year up here in the grim north!
Any Advice would be helpful??!!