Trackwork #4
Some more pottering about with trackwork went on over the weekend
Culminating in the handbuilt section being cleaned down and primed yesterday. Respaced the code 75 flexi to better match the rest of the track and removed the overcentre spring from the Y point as it will be servo operated.
Some minor tweaking has since been carried out, if you look at the centre NG rail just before the single bladed turnout you can see the gauge is too wide. Good job this is soldered track as minor adjustments like this are pretty easy. Oh and that isolation gap that got missed just ahead of the tie bar has been put in too!
- 4
- 1
1 Comment
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now