Hornby Class 50 ... Dead short when DCC fitted
A while back I acquired a Hornby Class 50. It caused a dead short on DCC. It got put on the 'Locos needing attention' shelf, and promptly ignored for a few months.
Accurascale then announced a Class 50 -- but skipped this specific variant (TOPS pre-refurb) in their announcement. So I decided to see what was wrong with this one, and if it could be fixed...
There's a lot of pointless stuff on the circuit board which is not necessary with DCC, so I went through it, worked out what it was for, what was causing the problem, and what I could safely remove. I then worked out a way to make it work in DCC -- it only needed a couple of wires adding.
I still need to get a set of headcode lights for it though...
Edited by Bloodnok
- 2
0 Comments
Recommended Comments
There are no comments to display.
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now