The bufferbeams are laminated from 2 layers, the outer layer is half etched with rivet detail, different front and rear. The buffers themselves are lost wax castings and needed a little bit of fettling, I held the shank in a pin chuck for this;
Here's the bufferbeams soldered up with the drawgear surrounds in place;
A bit of filler is needed where I cut the buffer shanks a bit too short in a couple of places.
I'll attach these later on after I solder the boonet in place.
The next job was the steps, made up from 3 parts. These are handed. Wet tissue paper was used whilst soldering these up as a heatsink to stop the asembly falling apart when the last step was soldered in place. A pic showing one step completed and the components for the other;
I used 188 degree solder for both the bufferbeams and the steps, when I attach them to the body I'll use 145 to prevent them coming unstuck.
Next job will be the gearbox.
Paul.
6 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now