Theory Becomes Reality
Finally some progress!
If you cast your minds back to my last post, I was trying to overcome the issue of short switch blades in 2FS using Easitrac components. Thanks to all your feedback, I now have a half built prototype.
Code 40 switch rail with a solid brass dress makers pin attached. The rail was notched out using the trusty piercing saw.
The above switch blade sitting in it's drilled out top hat bearing pivot point.
Two down, two to go! Then it's the "simple" matter of transferring it onto the layout
4 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now