More fiddling with track...
Salutations.
I have been adding short pieces of easitrac to the exit end of the board using home made brass sleepers at the ends, which have been cut through and pinned to the board for strength. Ballast drying over these at present. Just adding that bit of ballast/ PVA mix-goo makes me appreciate the simplicity of pressing ballast onto sticky tape and hoovering up the surplus.
I have ended up effectively rebuilding the switch rails on one of the points. As i said, you live and learn!
Can't proceed until these are 100% reliable, but geting a tad fed up of holding them open/closed to run trucks through now!
I got the 2mm AS wheels for my little 1F a couple of weeks ago- remember that? Some gears also arrived, and I have been sketching and planning the chassis / gearbox for this little engine, which is going to be the mainstay of the Little midland branch - although if course the 2F and Kirtley OF will make regular appearances, and there is the Spinner to tug the occasional summer excursion!
I've also paid a deposit on a new 0-4-4T kit... plenty to do keep me busy!
Best picture I can add thus far, thtough it all looks a bit messy at the moment:
This is the skect for board 2, which has little on it but the other end of the run round loop:
Regards,
Chris
2 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now