Point control
Hi all,
Here are some more snaps of my progress with the point operation. I've tried a dowel and pin into a block method as that was using materials I had to hand. I am very pleased with the results and the 'feel' is good, not too tight/stiff. Too much effort would have been a bit much for the pin over time I feel.
Here is the effort to transfer the motion through 90 degrees:
And here are the more straight forward points at the end of the platforms. Notice the block into which I drilled for the pin. These three at the front go into the front joist to support them fully and to minimise the potential 'bounce' of the dowel:
I've also made a start covering the platform surface with card. I'm using 'tarmac' sheet and plain card - basically all I had! It looks a bit patchwork quilt but will be covered. You can see the downloaded scalescenes paving on the left hand platform has been partially laid:
up close - I'm not 100% sure about the glued strip against the white edging?:
Cheers,
James
0 Comments
Recommended Comments
There are no comments to display.
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now