Turned out fine again...
Evenin' all.
I have been busy the past week wiring up the little layout board and installing connectors and switches.
Even a simple , one turnout layout seems to involve a lot of wire stripping and soldering.
Power is now running through the rails and 3-way - the latter after I traced a short down to a sleeper which was not quite cut through in one place..
However, and frustratingly,onto the loco used to test it out in DC ( both my blue diesels are DCC ready now), a Johnson class 2 0-6-0 with a Union Mills tender, avec turned down wheels. The association drivers pass quite easily through the three routes when pushed, but the tender wheels stick in places.
I am hoping that when I connect my NCE cab and stick a diesel on, the association drop-ins will perform better, otherwise its back to that tedious filing and resoldering to make it traverse smoothly.
Here is the wiring finally settled on - there are a few differences form the original plan ( which I still can't see much wrong with logically anyway!)
Regards
Chris
- 3
0 Comments
Recommended Comments
There are no comments to display.
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now