Jump to content
 
  • entries
    33
  • comments
    48
  • views
    2,634

About this blog

Reports on my 2mm finescale modelling of the Highland Railway in the Edwardian era. I'm moving over from Blogspot (http://ayeates2mm.blogspot.com).

Entries in this blog

Barney - progress

Time for an update on this engine. I've been progressing this build in between other things so it has been quite gradual to develop. This first photo shows me milling out as much clearance for the coupling rods as physically possible. Part of the problem was that the phosphor-bronze footplate is quite thick and extends further down than the real footplate, so I removed the worst offending sections, identified by trial and error with the chassis. For future locos I suppose I will design in these

antyeates1983

antyeates1983 in barney

Barney - design and etching

It's about time that I introduced my next locomotive project, which has actually been going on since before I started the Scrap Tank. It's a Barney 0-6-0. It started with the Worsley Works etch, but has morphed into a project using my own etches for the chassis and body, as well as for a 6-wheel tender (the Worsley etch provides the 8-wheel type). The main reason for not sticking with the Worsley etch was the fact that I wanted to do my own tender including axleboxes. I reasoned that I might as

antyeates1983

antyeates1983 in barney

Barney - tender

Progress will initially appear exceedingly fast because I'm trying to catch up with this blog! But rest assured that I was doing this construction in about November over quite a few odd hours.   First up, here is the tender chassis assembled. The spacers are 6.4mm PCB with gaps filed in on each side, soldered on using the jig described in the previous post. The horizontal one is set slightly below the top of the frames so that there is somewhere for the solder to attach on top. The ext

antyeates1983

antyeates1983 in barney

Barney - wheels etc.

The next thing I did was to add the reversing lever and smokebox door, which you can see in the photo below. The reversing lever was included (as a single piece) on the etch, but I struggled to fit it between the splasher and the boiler. I think this is probably because of the splasher being a bit over-sized compared to the prototype. In the end I had to file a curved bit out of the lever. The smokebox door was turned on the lathe, doing the curve with a graver. It has a spigot in the back locat

antyeates1983

antyeates1983 in barney

Barney - details

I've gradually been adding the remaining smaller details, which seems to take up a lot of time. This first photo shows those at the front end. The lamp on top of the smokebox was included as a "fold-up" job on the etch (similar to a typical 2mm axlebox). The handle is rather delicate and hasn't survived the process of soldering it together, but I don't think you can see it well anyway. I will make the lens using PVA glue after painting. The smokebox door handles are made from etched handrail kno

antyeates1983

antyeates1983 in barney

×
×
  • Create New...