Delph - Goes up in the world
Entry posted by Dave Holt
805 views
Those who have followed previous blog entries will know that I have not yet started the support structure for my Delph based layout. As a result, although I have placed individual boards on the (suitably protected) dining table to work on, any attempts to connect several boards together have involved having them on the floor. During a recent visit by Tim V, we managed to connect all four scenic boards, but this entailed moving the table and a coffee table out of the way to make enough space. All a bit of a pain.
Recently, I have worked on individual boards with them balanced on top a two dining chair backs. A bit precarious, but this has the advantage of raising the board surface to a less back-breaking height and also leaves the table free for its intended purpose! Then a thought struck.... Why not use trestle legs as temporary supports? Similar in height to the chair backs but more stable and leaving the chairs free! So, three pairs of plastic trestle have been accquired and found to be just the job. I haven't tried assembling the whole thing on these, yet, but a couple of sections have been connected so that a couple of loose rail ends could be re-soldered at the board joint. This assembly is shown below:
Over the past week or so, I've been fitting the cosmetic chairs to the soldered tack (mainly points, but also some plain track) on the board with most of the station throat point-work. There feels to have been millions of them, even though I've cheated by only applying the chairs to the visible side of the rails to halve the number required.
In order to fit them, any part of the brass rivet protruding beyong the foot of the rail has to be ground completely away. I used a small grinding disc mounted on the end of a flexible drive shaft to do this - very laborious and causing one or two of the soldered joints to break, needing repair before the chairs was fitted. Each chair moulding has to be cut in half and the cut ends trimmed back to allow the half chair to fit right up against the side of the rail. The chair halves were then attached using a strong plastic solvent (Plastic Weld). I used Exactoscale chairs because they do a wide range of chair types, which helps try to represent the various types of chair present in bull-head rail pointwork. The photos below show the results of my efforts:
The next job is to fit cosmetic fish plates at all the rail joint positions. There are lots of these, as all the siding track-work is supposed to be 30 foot rail. Where electrical isolation is required, I'll use the Exactoscale plastic versions and otherwise, Brassmasters etched brass plates. Then it's point rodding supports and the facing point lock arrangement.
Still lots to do, but it's coming along.
I hope to have a trial running session next week. If it accurs, I'll post a further item and photos.
Dave.
-
6
2 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now