LBSCR B4 an LRM kit by Weskie
LBSCR B4 an LRM kit by Weskie
by Weskie
__________________________________________
??? posted on Mon Mar 24, 2008 8:30 pm
I'm going to blame Andy Y. and the Modeller of the day comp. for starting this new thread.
Also the lousy weather we are having over Easter.
But it did get me quite eager to do some modelling. So here goes.
This is a London Road Models kit for a LBSCR B4 that I started about a year ago! It's gone together very well so far, the splashers over the front bogie were a bit tricky though.
I've just fitted pick ups to the motor so a test run is in order then we'll go on from there.
I wonder how long this bout of eagerness will continue?
I'll let you know in due course.
Cheers for now.
__________________________________________
??? posted on Mon Mar 24, 2008 8:45 pm
That's a good question. It will be set in 1908 to run on our club layout. 'Clarendon' so I suppose it will be Stroudley passenger livery. Not to gen'd up on Southern type locos.
__________________________________________
??? posted on Mon Mar 31, 2008 9:34 pm
Well, managed to give her a run, actually went better than I expected! Except why is it that given a choice of two wires to connect to the motor you always get them the wrong way round, Must be one of Murphy's laws.
It needs a lot more weight in it, nice long boiler to fill with lead and also hang the tender so to put weight on to rear drivers.
Here's a photo showing the chassis.
Would be nice to get it looking better for the show at Shepshed in April. I'd better get reading the instructions to remind myself what to do next
__________________________________________
??? posted on Fri Apr 04, 2008 9:22 pm
Right here's some close up pictures as promised. Better late than never.
First up shows the CSB on the chassis, using the LRM horn blocks (very nice) and just letting the beam rest onto the bearing instead of running through another handrail knob as I think Ted S. suggests. Being LRM horn guides they locate in a slot so the bearings don't wander along the axle. Hopefully that's fairly clear.
Yuk doesn't a close up shot show up all the muck you thought you'd cleaned off
Here's another showing CSB detail, this belongs to an Alan Gibson kit of a LSWR G6. This has got handrail knobs fitted to the top of the bearings.
And just to spoil you here is the completed thing.
Anyway back to the B4.
Next shows the front bogie (upside-down).
It pivots on a central bolt, with the axle beams also pivoting, and a wire soldered across the ends acting like a torsion bar. I think I'm right in saying this is an Alan Sibley design, but no doubt Jol will correct me if I'm wrong.
__________________________________________
??? posted on Sat Apr 05, 2008 1:28 pm
Hi Horsetan
The lack of handrail knob fulcrum is due to the lacking in width of the mainframe for the third pivot point, out of shot. the beam will deflect up when the weighted body is added, so should give enough room to push down as well. (I hope) I can always file some more off the sides of the horn guides if needed. Some packing on top of the bearing is also an option.
__________________________________________
0 Comments
Recommended Comments
There are no comments to display.
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now