Hello Again.
I seem to be on a bit of a roll at the moment. Yesterday was spent at the Didcot Show where I had a nice time talking to a few regulars as well as a few new people. Sadly though the modelling didnt quite go according to plan and I left the show actually having gone backwards, having less done than when I got there in the morning. Pride of place on my modelling desk though went to the Foden lorry...
I am really pleased with how this has turned out. OK, so the pictures dont really do the model justice but if it can pass the inspection of The Stationmaster with a huge magnifying glass then I am happy with it. The thing is though do I add more stuff? It could really do with some numberplates but I have also been thinking of some signwriting perhaps? What does everyone think? A big thanks goes to Rabs who without him this model wouldnt exist. Fingers crossed though that sometime in the near future a commercial printer will be available to print these so I can share them to those who would like one. Roll on the Morris van....
Today has been a little more relaxed affair and I have managed to do a little more on the point rodding...
Contrary to a short while ago I am now actually quite enjoying putting this stuff together. The milled 'comb' has changed what was a daunting thing into a quite enjoyable one and progress towards the signal box has been made. Currently there is roughly about 6 inches left to make but unfortunately I need to get the milling machine out once again to make some more comb stuff as I have run out. Then theres the fun bit of adding all the cranks to take the rodding int the signal box itself.
I might even finish all the point rodding by the end of the year the rate I am going!
- 16
17 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now