Getting nearer to a workable layout
Hi all!
As mentioned in a previous post I replaced my 14 Vac point motor control for 12 Vdc and purchased a new controller to replace the old Piko start kit. This meant that the 14V transformer became available to power the new controller. Since, as can be seen from the enclosed images, the transformer is relatively large and was previously mounted on the baseboard, I decided that I did not want either the transformer or the controller to be permanently attached to the baseboard. So, I installed two sockets under the baseboard for the main track and the programming track I have also installed. This latter can be seen on a shelf alongside the main track. The transformer and controller rest on an auxiliary table. Some tidying-up is still to be done but, at least now, trains can run.
Also, space has been left for additional scenic material.
- 1
0 Comments
Recommended Comments
There are no comments to display.
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now