Sand Dryer front elevation
More progress this afternoon with the front elevation of the sand dryer now complete. There are two 'I' girders above the window which I chose to fabricate from two pieces of brass section soldered together. The larger girder was cut and shaped from a piece of 4mm square section brass tube whilst the smaller one was cut from 3mm wide channel section.
Once finished the construction followed that of the end wall posted yesterday, with the only additional work required being the forming of the 90deg corners on the plinth and the single course of bricks.
Photographs of main line side of the dryer are rare but here is one to show what I am aiming to achieve.
Here is the front elevation shown ready for painting with grey primer.
2 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now