Jump to content
 
  • entries
    46
  • comments
    50
  • views
    16,004

Brake Van Special - Toad B


Yan

423 views

To add a little variation to the rake of brake vans for the Brake Van Special, I decided to dig out a Parkside's kit of a Toad B. I believe that some lasted into the 1960s in their original state so thought one might have found its way down to Cornwall. This is probably unlikely but as a Toad E was used on the Wenfordbridge Branch it might have happened...

 

When building plastic wagon kits I normally remove the plastic w irons complete with springs and axle boxes leaving just the wagon solebars. I then reduce the thickness of the solebars so that MJT W iron suppression units can be installed. Appropriate cast springs and axle boxes are then added to complete the running gear. In looking at the Toad B solebars I became aware of some very fragile components that, knowing me, would get damaged in the above procedure. This got me thinking of using MJT 2291 suspension units instead which would enable me to keep the Parkside offerings on the kit.

 

TOAD%2BB%2Bcompenstation.jpg

 

I believe the standard way to install these compensation units is to only use one rocking unit and insert bearings into the opposite end plastic axle boxes to create a fixed axle. In this instance, to make sure the ride height is parallel, I decided to install two units making one non rocking by slipping an appropriate thickness of plastic card between the mounting plate and the rocking assembly. The only other requirement was to create a groove in one set of the plastic axle boxes to allow one unit to rock.

 

Other minor modifications I made to the kit are:

  • Replacing the plastic buffers with white metal ones supplied by Lanakshire Models.
  • Replacing the plastic torpedo vents in the roof with Lanakshire Models castings.
  • Installing three link couplings.

 


 

I've left the roof loose so that a few figures can be easily added to each veranda. The model's weight can then be checked and, if required, more weight can be added inside the van.

 

Next stage is making and fitting all the hand rails... Hmmm, this should be fun!

Hand%2BRails%2B1.jpg
  • Like 3

0 Comments


Recommended Comments

There are no comments to display.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...