This is where I’ve really struggled, but happier with this than anytime previously. I’ve built the crane housing by adding windows to a Wills lamp hut, inverted the walkway along the crane and removed the original crane platform. Looking in Monk Bar models this afternoon made me dig out a Metcalfe brewery warehouse, and it might be combined with a workshop. I think I’ll remove the rear two columns of windows and replace with brick to allow for a clean join between the two. The brick section join could be covered by a down pipe. Some greenery between the bridge and the warehouse will hide the backscene a bit more, and I’ll put in a gateway somewhere behind the crane to give entrance to the area and also to the large factory by going under the bridge. I’d like it to look like it could work.

I don’t think I’ve posted a picture of the whole thing recently, so here it is...

Got a good 2’ to go at now, which will be nice to work on when it’s not so good outside. That bridge might get finished at last, it’s been like that for too long now. Then just the section to the small factory to develop. The front concrete apron is more than likely going to be a covered platform of some type, but that will wait to the end.

Thanks again for looking.