More Quick and Dirty Weathering
Entry posted by westernviscount
543 views
Hi Folks,
I've completed another wagon using the decalfix + powders weathering technique. This time around I have gone for a heavier finish.
The wagon is a parkside 13t Steel Open wagon kit. As before, the wagon is completed to ex-works condition, applying decals by modelmaster. With this wagon, I left it with the gloss varnish finish I applied for the decals to adhere to and attempted to apply the decalfix +powders mix. The solution pooled up and left a powdery residue upon drying which didn't look good at all. So, always work on a matt surface with the decalfix+powders.
So, after spraying the wagon matt varnish I applied decalfix + humbrol smoke weathering powder. The solution is applied all over the body, adding more smoke powder around the raised details. The blackness of the smoke powder naturally build up in random areas and can be made heavier by adding more powder as per the right hand end of the wagon here.
As with most weathering, lighting can change the effects quite drastically. With that in mind, it is worth weathering under the same type of light conditions as your layout is under or checking the look of the vehicle periodically.
Whilst the decalfix + smoke mix is drying, rust powders are worked over the top, thicker this time so they build up in areas to build up a rust texture as caught here on the right hand end. Again, lighting is everything and I have to say the effect isn't quite as pronounced by eye as it is here.
As before, the underframes were painted dark grey originally then worked over with a decalfix + brake dust mix. areas of fresh rust are dusted further with powder.
This time round I elected to matta varnish the vehicle to dull the sheen of the decalfix which was more apparent on this wagon van the planked van I did previously. Matt varnish spray should be used in thin powder coats as the heavier you go, the more the powders will be dulled. You may wish to dust your vehicle first (note the top lip of the wagon).
Although blurry, note how the texture looks different from this angle and looks a little "dusty" for my liking. The inside planking was done using a technique described in Martyn Welch's the Art of weathering.
A palette was prepared of humbrol 121, 64 and gunmetal. The 121 and 64 are stippled onto the planks, not mixing the colours entirely to make an uneven finish. whilst still wet/tacky the gunmetal is drybrushed on to create a weather worn unpainted plank effect.
I often become impatient and over do certain bits or don't follow instructions. Sometimes, I use the varnish spray in poor conditions (too cold) and over spray also. This leaves a frosty white finish which van ruin your model but in some instances can help create a faded effect like the top of the far side of the wagon. This also helped with the below example.
Again, I am pleased with the results of my recent flurry of modelling which usually comes of a good holiday! Again, if you do try theses techniques, do so on something non-precious!!!
-
10
-
4
2 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now