TS's kits blog

Lovely little wagon. I assume it's OO?

 

Looks like there's a slight curve to the body. Can that be rectified easily do you think, e.g. hot water and pressure?

12 minutes ago, Mikkel said:

Looks like there's a slight curve to the body. Can that be rectified easily do you think, e.g. hot water and pressure?

 

Not really, this resin is not thermoplastic. It's something I've seen on quite a few prints, though not really visable from normal viewing distances. Though oddly, I've just put a straight edge up against the red wagon and it's fine, so clearly my camera is playing tricks in this instance!

 

('tis indeed OO)

Many thanks. I consider you 3D modellers* to be pioneers and appreciate the challenges, so was just wondering. Even better if it's just the camera.

 

* I meant printers 

 

Edited February 15, 2020 by Mikkel