Stour Valley Dream - Let it rain
I did a bit of 3d modelling in CAD this weekend and produced some rainwater goods. This included some of the castings that hold the pipes onto the walls, some spouts for the bottom of downpipes and some hoppers for where one pipe goes into another. I also drew up some chimney pots and some suitcases, just for the laughs.
They came out pretty well on the Anycubic photon.
The holes in the drain components were drawn at 1.3mm and drilled out easily to fit some plastruct rod of that size. These were made up into various downpipes I needed.
The east side of the building has a downpipe for the gutters and a stench pipe, the later goes up through the roof.
On the other side has a pipe down the corner of the wall which joins on with the guttering from the lower part of the roof. I had to remove the guttering I'd attached to the lower section because I realised I'd made the overhang too long and it prevented the downpipe from fitting in. I'll fix this in a bit. There is also a downpipe for the lower section which goes down the wall of the toilet block. The windows still haven't been glued in yet as I'm still not I'm quite happy with them which is why the front of the waiting shelter isn't quite vertical.
As you can see the chimney pot got stuck in place too.
David
- 9
- 9
8 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now