Day 51: irritatingly close to success
Ah, the joys of 3D printing. The first test of the SER brake van (diag. 1553) looks to have come out ok at first glance - but a closer inspection shows that the print lifted from the print head on one side, meaning the footplate is warped up in one corner. Throw out, try again!
This is probably an issue with the print head levelling, which I triple-check before starting every print these days, as it's been so unreliable. Looks like I'll have to have another go.
- 1
- 1
- 4
2 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now