Day 58: SER brake testing
Well, I nearly missed a day! Today's effort was trial fitting some of the SER d1553 brake bits. The solebars and underframe have come out well, and fit, but the body on this one is a little bit warped, so I'm not going to build it up into a full test. I need to check the coupling height first, then I'll reprint and have another go. Shame, but hopefully worth it for the layout. 3d printing is very frustrating at times!
- 4
0 Comments
Recommended Comments
There are no comments to display.
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now