Jump to content
 

Day 65: more printing issues

TurboSnail

Entry posted by TurboSnail

178 views

 Share

I've been having lots of issues with my 3D printer again lately, namely that everything seems to be warping a lot more than it used to, despite everything sticking to the build plate better. This is the reason I haven't shown the SER brake yet, and the reason that the 3-plank isn't quite ready yet. Here's the result - not great, certainly not sale-able. I am, however, exploring a couple of options to get these produced professionally, at which point I could get more made at higher quality than I could manage on my own machine. We'll see where that leads!

 

day65.jpg.88f8ca31d0f00c0f14539c1cb9bfc442.jpg

  • Like 1
  • Informative/Useful 1
  • Friendly/supportive 1
 Share

2 Comments

Recommended Comments

MikeTrice

Once cured put them in near boiling water and watch them relax. If necessary you will probably be able to straighten them in your fingers and then hold them under cold water.

Link to comment
TurboSnail
30 minutes ago, MikeTrice said:

Once cured put them in near boiling water and watch them relax. If necessary you will probably be able to straighten them in your fingers and then hold them under cold water.

 

This is one of the tactics I've tried, and unfortunately it hasn't worked so far

Link to comment

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...