Saltney, Alterations,additions and a bit of scenery.
When the track was layed into the LM station, we knew we were on the very limit of curvature for most of the locos (we reckoned some of the curves were 4' 6" radius) and this proved to be too much for some. A re-think was necessary which resulted in much alteration of the woodwork and a reduction in complexity of the trackwork. We had originally envisaged a double track into the station but this was reduced to single. Many attempts were made before a compromise was reached.
As the corner by the door would be the first thing that people will see as they walk in, that area was chosen as the first to have a bit of scenic treatment so Steve and Les got busy while I got on with the wiring and point motors.
As the track layout in that corner had just about been finalised, the structure for the ramps was boxed in and painted black to act as a scenic base for walling etc.
The position of the turntable was by now ridiculously out of reach and as the LM station's layout had been changed, the plan to have kickback sidings feeding back round to below the site of the upper level was abandoned, freeing up space for a larger MPD area. Steve then added an extension board to accomodate the turntable and moved it down. Much better.
Meanwhile, I got busy sorting out which of the point motors scavenged from Talacre were usable, cleaned them up and started to install them. The first 2 were installed at the LM jc and as well as firing the points over, also operate the microswitches for point polarity.
- 1
2 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now