Hey up Folks

Now Ive heard a few people complain about the Bachmann V2 dome cover being too flat so..

All I did was get some milliput filler, mix a wee bit slightly bigger than the finish size of the dome cover.

place it and mound it the required size and shape, let it set and then gently file and sand it down the final size.

To get the height I placed a 6" steel rule lengthways along the top from the chimney cap too the safety valves,

the top of the dome should be on a level with the chimney and safety valves.

This is the first one I did what do you think?

And the second one, since finished.

many regard Chris