Brackhampton North Signal Box
Entry posted by rovex
823 views
Whilst I await some decent weather so that I can order the materials to line out the new shed without them getting soaked I've been dabbling with building the North Box for the station. This is based on the old one at Birmingham Snow Hill, which was some 50ft by 10 ft and stood on girder stilts because of the restricted site.
The basis of the cabin are some butchered sides from a number of the Hornby GWR Dunster Signal boxes, the windows whilst typucally GWR do not match those of the prototype but life's too short to get overly concerned with such matters. The photos give an indication of the work so far.
The box was electrically operated so no locking bars to model just lots and lots of cabling. The photos I've managed to dig up show lots of cables slung beneath the box and carried down the side of the stairs.
This shows the parts from the Hornby kit which are going to be used. I used four kits to get the necessary parts, I could have used fewer but that would have meant more joints. The windows from the remaining parts will be used on the South Box, whilst the level crossings I'll stick back on ebay.
These are the parts, with all but one trimmed and butchered. The windows turned out to be finer than I thought, obviously thicker than etched ones, but with a little work thinning the back of the frames down quite acceptable.
With the sides fitted to a new base, and some stregthening of the back wall. The only photo I have of the rear of the box, which because of the way it will be placed on the layout will be the public face of the box was unusual (well to me at least) in that several of the panels of windows were painted out. Perhaps even stranger whilst there is an obvious soil pipe for the toilet facilities, these appear to have been behind one of these painted out window panels (in this case the first one after the access door).
And now it sprouts legs. I was concerned that the girders looked strong enough to support the structure, and having glued them in place (evergreen plastic mouldings), was becoming a bit worried that I'd gone over the top.
cross girders start to go in.
Final shot for this post. Most of the girders are in place. There are two cross girders to go in at the ends to give "X" bracing. Between the other legs were a series of cabinets with sliding doors for stores so far as I can work out, and a panel carrying cables. Braces also need to be added from the top of the legs to the edge of the Box. These will be fun to try and cut.
The roof is loose for now to allow access to glaze the box after painting and because of the large number of windos to allow me to fit some kind of interior.
Rovex
-
1
4 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now