Starting the Scenery
Now that the electrics are finished:D I can start on the scenery for Hatton.
The large LEDs are a temporary signal - the scale ones are far too delicate to be installed yet.
The foam is Knauf Space Board and the second layer will lift off to give access to the tracks below. I need to build a Scalescenes tunnel mouth and then trim the foam back to suit. The backsecene board is foamcore. To make it bend cut a vertical line on the back every half-inch or so and then break the foam along the line. The backscene will be one of my customary iD products from International Models.
Question.
Should I leave it as a hillside or have a factory perched on top?
The train is about to go over a canal and then past a car park on one side and industrial units on the other, followed by the station and then the town.
What does everyone think?
4 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now