A1 Models Freelance 009 Diesel - part 2 cab.
I've been working on the cab.
This comes etched in one piece;
I've drilled holes for handrails and door handles. Strangely the left hand side door has the handle at the front and the right hand side door has the handle at the rear.
Folded up and soldered together;
All bends are re-inforced with a fillet of solder, not strictly necessary perhaps.
I used a Bill Bedford handrail jig to bend up the handrails, which are made from .45mm diameter brass wire. Door handles are .33mm diameter.
All soldering so far done with 188 degree solder. To solder the cab to the footplate without melting any previous joints I used 145 degree solder;
188 flows much better than 145 resulting in neater joints. The joint between the cab bottom and the footplate still needs some cleaning up.
Paul.
- 4
2 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now