Professionally built 00 DCC layout

Hello

A couple of quick questions:

1. Would you be able to provide a copy of the track plan, or even a picture from above / high level displaying the track layout. 
2. What type of motors/solenoids are used to electrify the points
3. Where are you located

Many thanks

Darren

buckleywells 1

Posted October 20

Hi Darren

Sorry for the apparent delay in replying, but this only just appeared in my RMweb feed!

I attach a rough sketch of the trackplan superimposed over the details of baseboard dimensions etc. Basically it is a single track circuit with ability to reverse direction either way. (Polarity switching is automatically handled by two Lenz units). 

The points are operated by PECO solenoids.

The layout is in South Oxfordshire. 

I have a short video clip giving an overview, but cannot post it here. However I can send it by email (my details below), and answer any other questions you may have.

regards

Martin Lyons

[email protected]

 

Hi There,

 

I can't see the answers to Darren's Questions?

 

But I am unfamiliar with this area of RM Web!

 

Thanks

Paul

buckleywells 1

Posted October 20

hi Paul

I hope you have the info now

regards

ML

Hi Martin,

 

I can see your reply to Darren, but I cannot find the track plan you refer to?

 

All I can see is the original baseboard plan!

 

Cheers

Paul

buckleywells 1

Posted October 20

Still finding my way around this software as well.

Try this

Sorry Martin, but can't see any attachment to your last post, and now your original baseboard plan shows as unavailable!

 

Let's hope someone see this and offers some help.

 

Keep trying!

 

Cheers

Paul

buckleywells 1

Posted October 21

hi Paul

I have sent a message to the administrators.

Yet again I will try to send the track plan. Best to email me direct with any further questions

Thanks Martin,

 

Success at last!

I will digest this and get back to you via a PM if necessary.

 

Many thanks

Paul

What sort of price are you looking for? Would you consider selling the boards without the Gauge aster controller?

buckleywells 1

Posted October 23

Hello

£1500 ONO , (less than a quarter of what it cost from the builders). Would adjust if you dont want the controller.

regards

ML