Leaderboard

Evening all, I have decided to set up a blog of my 7mm efforts mainly as I prefer the blog format to the layout threads...too much scrolling backwards to find stuff! This project was started back in BCN when I was having a 2mmFS lowpoint and I confess there is something nice about jumping between the two different scales. Rather than repeat, I will do a short summary intro here but if anyone would like to read in more detail the thread can be found here: http://www.rmweb.co.uk/community/index.php?/topic/12616-wenford-dries-7mm-1983/ Having always been drawn to China clay and my preference these days for building extracts from prototypes to try and capture the atmosphere, Wenford came in to being probably from an image seen in Maurice Darts superb book ‘Cornish china clay trains in colour’. This seemed the ideal chance to build a small 7mm toe dipping exercise in the senior scale. A Bachmann Brassworks 08 was purchased secondhand and at that time I think the Dapol 08 was not known about. This was followed with 4 Skytrex clay hoods, a Skytrex vent van and a Slaters Brake van kit to recreate the photo from the book. Could this be the first layout where I had bought all the stock prior to layout construction and not end up with an inversely disproportionate stock box to the size of the layout? Well...it could have been if Dapol hadn’t have brought out that 08 at bargain prices! It started with a sketch as most of my layout ideas do...and the use of Ikea Lack shelves as boards... This was developed into a small scale model in white card... Mock ups were produced using crude track templates...this took some time to get right... This was then mocked up with boxes to give a sense of the dries building... Track building commenced in UK using C+L turnout in a bag kits...and Deb’s 31.5mm gauges Track was completed and wired a couple of years ago... And then that Dapol 08 appeared which just had to be purchased... Following some running sessions it all went quiet again until now as I am having another 2mmFS low point! Time to refocus and good to zoom out a little. This brings us almost up to date as the next step is to laser cut the fascias at work from 3mm plywood. I have drawn the CAD plans but decided to mock up the proscenium arch before I cut out 10 or so sheets of ply Armed with foamboard last weekend and a couple of hours I mocked up one end and some of the building at the rear. This led me to reduce the viewable part of the layout to 250mm high which given the width is ok I think proportionately (the initial 300mm height looked too much when first made) It’s crude but has allowed me to tweak the CAD plans accordingly so well worth the effort. Infact I have just brought home some more foamboard to review and build the opposite end and I may try to undertake that this weekend. Here’s some images of the mock up... The main idea of this layout is to try and demonstrate that it’s possible to have a bit of fun in a small space even with 7mm scale. Although quite limited in its scope, it does allow you to shuffle and rearrange the wagons around and the Dapol 08 is soundchipped with the Paul Chetter DCC sound chip which sounds terrific. Another board could be added to the right hand end to make the passing loop but for the moment the aim is to try and complete this as a way of gradually easing into the scale due to more and more frustrations with eyesight and patience as I grow older As always, comments welcome, Pete

https://www.facebook.com/tim.hall.146/videos/1482512998519610/?t=4