Diane

Good to see that the layout is progressing again!

I've just realised that I can extend the siding through the backscene to add operating interest!

Hi I made a decision to use KD couplings because they can handle sharp curves without causing derailments. I have however had problems with the uncoupling because I have not been able to obtain the face magnets required. The point is a Peco Setrack Y point, but I intend to replace it with a Setrack Right Hand point, because this will allow me to ease the approach curve. Diane

Hi I was travelling from Euston to Crew by Virgin Trains last week. I had the layout on the table and using the power from the socket under the table, I ran in the red 0-4-0 locomotive!

Hi I intend to scenic the front half including the siding, The intended Industry is the china clay dryers. I will use Peco Loco cassettes as a fiddleyard.

Hi I have a very small 4mm industrial layout. A photograph of which is shown below. Diane

Most people would put the blocks on the other side of the back scene. Obviously this is part of a cunning plan!

Hi What type of paint will you be using to finish the cottages? Diane