nelly

Sorted!! many thanks to the forum.

Will double check… thank you for taking time out to do this. BYW- I do not have a lokprogrammer so just using my ECoS.

Thank you for your assistance. Unfortunately, so far no luck.

Very interesting. I too have DCC sound fitted (green) class 37. Has anyone been able to code up a kadee uncoupling waltz? I'm flummoxed, even though I have downloaded the v5 loksound guide and attempted the function mapping. I set the following: CV 31 value 16 CV32 set to mapping line value CVH ( F26 which is vacant,) CVN (uncoupling cycle) value 64 both set to mapping line co-ordinate values CV31/32 reset to zero. Cv 246=5 247=244 248=150. nothing moved. Have I missed something? cheers

Thanks- waiting to hear any other reports. I’ve asked a colleague to test a piece on her Cricut and I will post the results in case anyone else is considering a machine.

Hi could anyone advise whether a Cricut machine is capable of cutting through Wills modelling sheets as supplied in blister packs and their Craftsman kits please. I am considering purchase. cheers

Cheers. Sorted out the frog issue as per your advice.

Hi thankss for the reply. There are three frog droppers attached to the Peco point. One per motor via the Switchpilot Extension module. What about the third dropper? Where does that go?

Hope that someone has fathomed this out... I assume that I use two ports of the switchpilot, one for each sub-turnout but how do I wire up the three frogs to the two Extension ports? Do I take a spur off the middle one and pair up to each of the other two? following on… thanks to advice posted in reply, I have sorted out the above issue. However, a new one emerges… I use the ECoS system and the feedback method via the Extension modules. Now can only obtain correct feedback for two of the three point positions despite swapping over terminals. Is this just me or has anyone else found this ( and fixed it)?

Hi I’ve come to the party a bit late but find this topic exciting and wish to attempt it. Before getting stuck in, could you please clarify what you mean by resetting index CV’s to 0 before proceeding further... What index CVS are you referring to? cheers Nelly

So where can I get an OO scale broom....?

I agree totally with those who find the search facility for the forum near useless. I’m trying to research what width of white line I should use for my platform edge- OO scale LMS mixed steam/diesel era Can anyone assist?

Thank you guys!

This one has stumped me. Can anyone assist please? I’m planning twin track junction off from twin main line. I envisaged two short left hand points (SL-E192) and a diamond crossing (SL-E193) This does not work due to shallow angle of diamond crossing. I also wish to maintain streamline permanent way. How is this possible and what items do I require?

Sorry about that...