Artificer1

Hi, Can someone please give me some guidance on how to programme the Hornby R8427 4 way accessory controller using JMRI for turnout control. Thank you

Hi, came across this post, can someone give me some guidance how to programme the Hornby R8427 using JMRI for turnout control.

Please see attached circled ‘2 aspect ground signal’ . What are the colours of the lights If they where showing and does this signal work in conjunction with the L/H feather ? thank you

Thanks to all that responded to my question. Regards Robert

Thank you , I have a selection of resistors in my ‘come in handy’ box I will try an identify a suitable rated one if not purchase a recommended.

I have recently purchased ‘micro litz wired leads SMD LEDS’ the packaging advised 2.8 - 3.4 V supply , however when applied from 2 X 1.5 v batteries LEDs failed. Supplier now advises supply voltage should be 1.8 - 2.2V . Can someone advise how to reduce voltage . Regards Robert

Picked up on a previous thread , Enquiry : I have recently purchased DCC80 autofrog 3 pack, my question is , 'why can you not connect multiple frog input wires to one frog polarity switch on the basis only one turnout is operated at a time. ' the DCC bus remains common to all .

: I have recently purchased DCC80 autofrog 3 pack, my question is , 'why can you not connect multiple frog input wires to one frog polarity switch on the basis only one turnout is operated at a time. ' the DCC bus remains common to all .

Thank you for all your responses, much appreciated. Robert

I have installed 3 way points ( effectively operated by 2 surface mounted motors) my intention is to install routing lights visible from a control panel, as the routing to the 3 ways is dependant on the combination of the 2 point settings, I am not sure of the wiring circuit to achieve indication , i.e. One green, two reds. Any help would be appreciated. Regards Robert

I have installed 3 way points ( effectively operated by 2 surface mounted motors) my intention is to install routing lights visible from a control panel, as the routing to the 3 ways is dependant on the combination of the 2 point settings, I am not sure of the wiring circuit to achieve indication , i.e. One green, two reds. Any help would be appreciated. Regards Robert

I'm trying to put together a full rake , now that Hornby have released a set of 3 coaches. Does anyone have the actual running numbers of the carriages being used for the Penzance / Paddington night sleeper train.