wpslo

Stuck this here and hope it helps . Monday, 2021-08-02 https://dccwiki.com/Wiring_Crossings _Peco_SL-E194 . Code 75 Electrofrog Large Crossing _Hornby_R8238_Reverse_Loop_Module_ See this diagram for an explanation of the nomenclature : https://dccwiki.com/Wiring_Crossings _Diamond_Crossing_Wiring_ using a _Reverse_Loop_Module_ [ _RLM_ ] . I hope this will help with the problem . It is a report of my solution to the problem using a Peco_SL-E194. Picture the crossing with the long axis horizontal . Working from left to right I will refer to the four wires fitted to the crossing as: A & B [ left pair ] and X & Y [ right pair ] . Think battleship gun turrets . What I did: 1. Fit insulated fishplates to the End_Frogs ; a total of four . 2. Fit conducting fishplates to the Frog_Arms ; a total of four . 3. Connect B and X to the Track Bus . This means that that the four crossing rails [ the short rails immediately outside the diamond in the middle ] will be permanently live . 4. Connect A and Y to the two Track Outputs of the RLM, i.e. Power Out . 5. Connect the Track Bus to the two Track Inputs of the RLM, i.e. Power In . 6. I am not sure if it matters which way round either of these pairs are installed as long as the inputs and outputs are not mixed . However it may be necessary to pair the End_Frog wire with its associated Frog_Arm . Note: Only one RLM is required so this is probably the cheapest solution to the problem .