peter1

Hi Just stumbled across this thread, sorry if it's too late. I'm using Rocrail with my NCE PowerPro 5. These are the settings I've used for my system. The com port is where my usb/serial convertor is attached. Hope it helps Peter

My recent experience with Phil and the rest of SLW, was very positive. My CL 24 D5000 which I purchased in 2017 developed a fault. It turned out to be the motor that was the problem. I contacted SLW and spoke with Phil, they in turn, provided me with a replacement motor, free of charge and postage paid to Australia! How's that for service? Peter1

Hi guys, I did heed the warning on the booklet and programmed the two decoders separately. I turned off the layout power and gave up for a while. When I returned to have another go lo and behold the 156 responded to the long address !!! I will try the layout later today and see what happens Peter

Mine arrived unannounced yesterday,RT156-112 smashing model, but I have an anomaly with the sound decoders. Using my NCE power pro (5amp) I can change the address to a long one i.e. 1561. But when the 156 is stopped, it won't then respond to the move command! All the lights, sounds etc respond to this long address. But the model will only move if I set the address to the default of 3!! I've tried a cv8 reset but the same thing happens again. Any suggestions will be most welcome. Peter

Still waiting on my order for RT156-112 sound fitted. Order no. 379 Unfortunately the Glasgow show is too far away from Sydney Peter