Recently, I bought the Class 5 from Rails of Sheffield. The loco is alright and ran perfectly fine on DC while running in. After putting in the Bachmann 36-568A 6 pin decoder and giving it a new adress on my Select, everything seemed to be ok. That was until the loco ran for 2-3 minutes, when it slowly came to a complete halt, no overload flashing on the Select nor did the loco start smoking. After I switched of the controller and started running the loco it did the same thing, run fine for a bit and then slow down to a halt. I then forgot about it, and when I ran it today, it did it again. Twice.
I already eliminated motor issues, as it ran just fine on DC, so it's either the decoder or the Select. The pins on the decoder are a tad bit long, but I doubt it's causing this problem, the decoder doesn't touch anything else and is plugged in properly.
Please help, I live in Continental Europe and it's a pain in the arse to ship things to and from the UK.