adrias

Thank you friend, you are right about turnouts but I dont include them in blocks. It is not a software for presenting the occupation is appearing like this on my command's center screen (ECos2). Thanks for your answer anyway. Ioannis Trimpos

Dear friends, what I want to ask about is the operation and appearance of an occupied block. In the figure below (1), the block appears occupied with the loco immobilized with lights on: (please see figure 1) When the locois in motion (irrespective of direction), it is presented as falsely occupied and just above the block as shown in the following figure (2): Detailsabout the two blocks: The bottom(beyond the gaps at the bottom of the line) and the connection to the DR4088 CS has no other connection (eg: power supply, etc.) The DR4088CS connects to ECOS2 through its S88N Out output with the ECoS S88N In respectively and powered by it. The upperblock in addition to gaps and connection to the DR4088 also has line feed. (the result is the same even if I remove the feed) The twocurved turnouts on their right have no power (apart from their switches) and they are insulated in their bottom line with gaps because they are outside the two blocks but also the two next to the right. So they're out of power. But even when I give them a stream the result is the same. If theturnouts are included in the blocks, the result is that some other blocks are falsely occupied again. What am Iwrong and what should be done? I'm using ecos2 + DR4088 CS - HO DCC 2 Line.