KieFowler27

Humbrol RC418 is what i went for

N/a

Cheers lads, yeh I saw that dcc77 and thought that’d be alright so he will probably go with that cheers

Have a GM prodigy express with the WiFi, we want too use the controller for mainline operation and the WiFi/ phone app for shunting and depot moves however the express power pack has one out put port, can I use a prodigy extension (dcc011) from gaugemaster with an express hand set as it says it’s for use with the prodigy advanced ? Just too double check, if not that, is there an alternative solution ? Cheers

Spdts running into a cdu, cdu too 16v ac

Plan too wire point box for dcc with leds, using seep pm1 motors, does dcc mean I can operate the leds variable positives and negatives from the frog/ terminal f and then power the common led feeds from the tracks dcc bus wire and daisy chain said wires too each respective set better than dc ? I tried testing this using a dc combi and the leds would work right but the controller/track feed wasn’t operating right and I later read that dcc enhances the ability for this too work ? Is that right or would it still not Make a difference? Basically I want to operate which leds light up on the panel from the points frog and power the leds by the tracks buss wire feed, it doesn’t work on dc but will the same way work on dcc ?

I plan too build a dcc layout with around 30 seep pm1 point motors, and 30 electrofrog code 75 points using 16 curved for the fiddle and 14 for the medium straights for the scenic section, how many cdus would this require and what type is best, have read that it doesn’t matter how many points on the layout there are and that you can use only one cdu however, the gaugemaster and other cdu sites state a max of 6 points can be used per cdu, does this mean that the 6 points are moved at the same time and that id only need one fairly powerful cdu for all 30 as it’s likely I’ll occasionally only move around 5 or 6 pints (fiddle yard changes and scenic switches) and in short time (2/3 seconds) between each switch or that I’d need 6 cdus too run 5 points Each for the whole layout ? Thanks for any assistance